common size：48CM Width*200yard per roll，2rolls per carton，other size can be re-orderd。

　　Hot melt adhesive film is currently in the embroidery industry has been referred to as hot glue or gum, because of its smooth surface without adhesive, acid, alkali, washable, dry-cleaning performance and anti-tension, followed by strong, low melting point and in line with all Fabric processing standards in general and then, over the years the domestic electricity sector has been embroidered into line with Europe and the United States, and gradually replace the low-quality rough seam line LOGO (embroidery badges, armbands, and other plastic s), the hot glue is the industry's Embroidery sure adhesive film.

　　Our hot melt adhesive film is also applicable to hot melt thermal transfer printing film, hot drilling, heat transfer, flocking with hot melt adhesive film, wire and cable car foot pad with hot melt adhesive film, hot melt adhesive carpet exclusive Laminated type of membrane, as well as trademarks cloth, PVC hot drop models trademark of high-frequency voltage in the foot, above the carpet. Seamless underwear, clothing zipper cloth, so tongue-specific standard hot melt adhesive film, low temperature hot melt adhesive film, flame retardant hot melt adhesive film, aluminum, hot melt adhesive films shared blanket pressure (with the printing plates), forces hot melt adhesive film exclusive badges for various uses hot melt adhesive film.

The general usage of hot melt adhencive film：
1. To a single chapter of the embroidery or the embroidery finished just embroidered the whole pressure on the iron horse to the machine,
2. Will have a hot melt adhesive side of film towards Chapter embroidery, while the direction of pressure release paper machine heat hot plate,
3. Pressing 5-10S, the release pressure hot machine, tear up the release paper to be cooled, when the embroidery will bring a chapter on a layer of plastic, we call the gum, when the chapter can be embroidered Chapter referred to as gum.
4. The use of tools or manual methods to reduce excess corner can place plastic.
5. Customer (garment factory) bought a chapter with a good adhesive, as long as the plastic side will take place towards clothing with pressing machines or other heating equipment can be sticky Chapter embroidery on clothes.
6. Embroidery cartoon was stick to clothing, the fastness, and washable alternative to traditional truck-pin method, and high efficiency.